DDR Metal pad wires

[Sentin]

I have a red octane metal pad. Its slightly older version and heres a picture of it:




The problem is the wires underneath the up arrow have been ripped and I need to know what wire connects to which wire. Does anyone have one or have a picture of all the wires inside of it so I can look and attempt to repair it? I dont want to spend another 250$ + for another metal pad when I can try and repair this one.

[ChilliumBromide]

Which wires have disconnected?
If it's like the tx1000-ish pad I have, and the sensor-wires are what you're referring to, just reconnect one wire to one of the two metal connector plates and the other wire to the other connecter plates. (the plates, once again supposing the sensor is the same, are comb-shaped metal bits that alternate lines, but don't touch.)
_________________

I used to be active here lol

[Sentin]

Your referring to the arrows. These wires are the ones from the cord that connects to the controller box. Under the up arrow theres a bunch of cables from the cord. Those are the ones that are disconnected.

[ChilliumBromide]